The Snappi Diaper Fastener is a clever little gizmo that can be used instead of diaper pins to hold a flat or contoured diaper in place under a cover. You don't need pins or a Snappi if you're using one of our velcro diaper covers, but it is a quick and easy way to keep the diaper from shifting around--especially on an active baby. You can also use it to keep a flat diaper in place without a cover when your baby is just hanging out at home.
The Snappi works best on Diaper Service Quality prefolds, is OK on Kissaluvs Contours, and is not recommended for felt or other closed-weave diapers.
The thee ends of the Snappi have little hooks that grab the diaper without ripping it. Attach the sides first, then draw down the middle to hold it on tight.
The Snappi fastener is manufactured from FDA approved raw materials, a polyester based polyurethane which is degradable on aging through hydrolysis and/or microbiological attack. It contains NO latex or any other adulterant, dilutent or modifying polymers. The composition is 100% polyurethane. It is made in South Africa.
Sold in packs of 2 in assorted colors.
Important Notes and Disclaimers:
CAUTION: Improper use can cause injury or pose a choking hazard. Always use a cover when using a Snappi fastener on your baby’s diaper and keep it out of children’s reach when not in use. Do not cut your Snappi--This could create weak spots in your Snappi. Inspect your Snappi before each use and discontinue use immediately if there is any sign of cracking, tearing, breakage or wear of the teeth or any other parts. The Manufacturer recommends that you do not use your Snappi for longer than 6 months. And, do not leave your Snappi lying in the sun. It is not UV resistant and this can reduce the effectiveness of the Snappi. The best way to clean to your Snappi is to wash in warm soapy water. Do not launder them with diapers in the washer as this may weaken the grip attachment.
